EPDM Roofs in Crewe

Thinking of EPDM for that leaking kitchen extension?

EPDM installs, replacements and repairs on Crewe homes and outbuildings

CALL US HERE - 01244 740253

GET A FREE ASSESSMENT

An aerial view shows a partially reroofed brick house with new dark gray tiles on one side and old, weathered tiles on left.View from above of a flat, dark gray roof, looking down toward a suburban street with parked cars and apartment buildings.

We fit EPDM roofs in Crewe on garages, porches, dormers and large rear extensions alike. Most installs start at around £1,500 and stay under £4,000, and a new EPDM roof should give you up to 40 years. For a flat roof, that's about as much life per pound as you'll find.

The material arrives on a roll big enough that a typical domestic roof can be covered in one piece. Fewer joins means fewer places for water to find a way in.

This page covers where EPDM fits on Crewe houses, how we lay it and what the cost depends on. For the other systems, see our flat roofs in Crewe page, and for our full local service list, visit roofers in Crewe.

Where EPDM works on a Crewe property

Rear extensions

The classic use: a kitchen or dining extension on the back of a semi or terrace, with its flat roof tucked under a bedroom window. EPDM is bonded cold, with no torch, which matters when the roof sits right beside uPVC windows and timber fascias. Done properly, the edges finish under neat trims and you barely notice the roof from the garden.

Garages and outbuildings

Garages beside the semis and bungalows in Wistaston and Shavington often still have felt on top. Swapping to EPDM costs a bit more than re-felting but should last considerably longer. It's also light enough to go onto most garage roof structures without any strengthening, so the joists rarely need touching.

Dormers and small roofs

A dormer roof is small but awkward to get at, so the last thing you want is to go back up every few years. EPDM's long life makes it a good fit. It also suits bay window tops, porches and canopies, where a single offcut can cover the whole area without a join.

1,000+ Roofing Projects

Friendly & Reliable Team

EPDM and the conditions in Crewe

On the flat, open ground around Crewe, wind gets at flat roofs from every side. EPDM is fully bonded to the deck rather than fixed only at the edges, so there's no loose sheet for a gust to get under, and the perimeter trims hold everything down. The material also handles ultraviolet light well, which counts on a south-facing extension that bakes in July and freezes in January. Both extremes are normal here on the plain.

A lot of Crewe's Victorian terraces have a back extension with a flat or shallow roof, and it meets the main house at a brick wall. The detail at that wall, where the EPDM turns up and the flashing comes down over it, is where we spend our time. On newer homes in Leighton or Basford it's more often dormers and garage roofs, with easier access but the same principle.

Laying an EPDM roof

Free survey

We measure the roof, check the deck for soft spots and look at where the water drains. Your estimate, written and verbal, normally prices a standard and a thicker grade of membrane so you can choose between them.

Prepare the deck

Old felt or covering is stripped off. We replace damaged boards, add insulation if it's needed and correct the fall so water runs to the gutter or outlet. EPDM needs a smooth, clean, dry base to bond to, so this stage isn't rushed.

Bond the membrane

The sheet is laid out to relax, then bonded with adhesive across the whole deck. We work out the creases, form the corners and upstands, and seal around outlets, pipes and any rooflights, using the manufacturer's own primers and tapes.

Trim and finish

Edge trims and drip details go on to throw water clear of the fascia. We clear up, send you photos and video of each stage and hand over the roof with guarantees that cover the membrane and our fitting of it.

Why Crewe homeowners choose our EPDM roofs

  • One-piece sheets wherever the roof size allows, so there are as few joins as possible.
  • Cold-applied, so there's no naked flame near your windows, fascias or a timber dormer.
  • Fully bonded and properly trimmed to resist wind sweeping across the open Cheshire plain.
  • Decks repaired and falls corrected first, so water drains away instead of sitting.
  • Prices from around £1,500, with the grade of membrane spelled out in the quote.
An aerial view of a building with a partially tiled roof, neighboring houses, and a green field under a cloudy sky.A house roof under construction, featuring new dark tiles, partially installed solar panels, and surrounding scaffolding.

How much does an EPDM roof cost in Crewe?

Most EPDM roofs we fit start from around £1,500 and come in under £4,000. Where you land depends on roof size, the grade of membrane, how much of the deck needs replacing and whether insulation is going in. A single garage sits near the bottom; a large insulated extension with a rooflight to work around sits near the top.

Here's a worked example. Say you've got a modest kitchen extension on the back of a terrace in the older streets near the station. The membrane itself won't cost much, but if the deck is soft and the roof has to be insulated to meet Building Regulations, that adds boards and time. Then there's carrying everything through a narrow back yard. We price all of it up front, so the figure doesn't creep.

EPDM Roofs in Crewe: Your Questions

Does Cheshire East Council need to know about my EPDM roof?

Not for planning in most cases; re-covering a flat roof that's already there is generally treated as maintenance. Building Regulations are a separate matter: renewing a quarter or more of a roof normally means upgrading the insulation, and building control should be notified. If your home is listed, ask Cheshire East Council before changing any roof covering.

How does EPDM stand up to a windy winter?

Well, provided it's fully bonded and the edges are trimmed properly. Most wind damage to flat roofs starts at a loose edge or a lapped joint. With EPDM bonded across the whole deck in a single sheet, there's very little for the wind to catch hold of. On exposed roofs we check the perimeter with extra care.

Can you fit EPDM on a Crewe terrace with a tight back yard?

Yes. EPDM comes on a roll and is light, so it's easier to get through a house or down an alley than heavier materials. Because it's cold-applied there's no gas bottle or torch involved either, which helps when the roof is right next to a neighbour's window.

How long will an EPDM roof last?

Up to 40 years when it's laid well on a sound deck. What shortens it is poor preparation, ponding water and edges left loose. Keep the outlets and gutters clear, have a look after a big storm, and there's very little else to do.

Can you repair an existing EPDM roof?

Usually, yes. Small punctures and lifted seams can be patched with matching membrane and the right primer and tape. If a roof keeps failing in the same spot, that often points to a deck or drainage problem underneath, and we'll tell you if that's what we find.

What To Do In Crewe

EPDM Roofs Elsewhere In Cheshire And North Wales