Flat Roofs in Crewe
Is the flat roof on your extension starting to hold puddles?
New flat roofs and replacements in EPDM, GRP and felt around Crewe
CALL US HERE - 01244 740253GET A FREE ASSESSMENT


Flat roofs in Crewe are usually the back half of the house's story: a kitchen extension someone added decades ago, a garage built onto a semi, a bathroom tacked on behind a terrace. They're cheap to build and they do the job, right up until the felt crazes or water starts sitting in the middle after every shower.
We fit and replace flat roofs in three main systems: EPDM rubber, GRP fibreglass and torch-on felt. Each has its place. The right one depends on the size of the roof, your budget, how long you plan to stay and whether anyone will be walking on it.
Most of our flat roof projects come in between £3,000 and £10,000. Below we compare the systems, explain what we look for on Crewe properties and set out how a replacement runs. Our main Crewe page covers our other local services.
Three flat roof systems for Crewe properties
EPDM rubber
A single sheet of synthetic rubber, so on a typical rear extension there may be no joins at all across the main area. It's light, it flexes, and it copes with the swing between frosty nights and warm afternoons. It's our usual recommendation for a domestic extension nobody walks on. The detail is on our EPDM roofs in Crewe page.
GRP fibreglass
Laid as resin and glass matting, then cured into a hard one-piece shell. GRP should last 30 years or longer and handles foot traffic well, so it suits a roof you step out onto or one that needs regular access for a flue or solar panels. It costs a little more than rubber and needs a dry spell to lay.
Torch-on felt
Modern three-layer felt is a long way from the thin sheet that used to curl up at the edges of garage roofs. It's the cheapest of the three to install and easy to patch later on. For a shed, a garage or a small porch where the budget matters most, it's a sensible choice.

1,000+ Roof Repairs
500+ Replacement
Flat roofs on Crewe houses: what we look out for
Crewe's older terraces were built with small back yards, and many have since gained a flat-roofed extension at the rear. Those roofs usually butt up against a slate main roof or a brick party wall, and the junction is where leaks begin: a flashing that was never chased into the brickwork, or a felt upstand that has shrunk away from the wall. When we replace a flat roof we rebuild those details properly rather than lapping new material over old mistakes.
On more recent houses around Leighton, Coppenhall and the edges of Shavington, flat roofs are more often over garages, porches and dormers. The usual fault there is drainage. A flat roof needs a fall to shed rain, and when the deck sags or the fall was too shallow to start with, water sits. Standing water ages any membrane faster, so we correct the fall during the rebuild.
Replacing a flat roof, step by step
Survey
We look at the covering, the deck beneath it, the drainage and the junctions with walls and the main roof. Soft spots underfoot usually mean the boards have taken on water. The estimate comes in writing and in person, usually with two or three systems priced side by side.
Strip back
The old covering comes off and we check the deck and joists. Damaged boards are replaced, and if the roof needs a better fall we add firrings or tapered insulation. You never see this part afterwards, yet it decides how long the new roof lasts.
Lay the new roof
The chosen system goes down: EPDM bonded to the deck, GRP laid and cured, or felt torched on in layers. Edges, trims and upstands are fixed and sealed, and the outlets or gutters are connected so the water has somewhere to go.
Check and hand over
We water-test where it makes sense and leave the site clean. By then you'll have had photos and video of every stage. The new roof is guaranteed for materials and workmanship, and we'll tell you what, if anything, it needs by way of upkeep.
Why Crewe homeowners pick us for flat roofing
- We fit all three main systems, so our advice isn't steered towards one product.
- Decks and falls are checked and corrected, which is what actually stops water ponding.
- Junctions with slate roofs and brick walls are rebuilt properly instead of being patched over.
- Quotes set the options side by side, with expected lifespan next to the price.
- Photo and video updates of the deck and insulation before they're covered up for good.


Flat roof prices in Crewe
Most flat roof jobs we do cost between £3,000 and £10,000. Roof size is the starting point, then the system, then the state of the deck underneath. Say you've got a single garage roof on a sound deck: that's towards the lower end. A large kitchen extension needing new boards, extra insulation and a corrected fall will sit well above it.
A Crewe-specific factor is access behind the older terraces. Materials and waste often have to come through the house or along a narrow alley, which adds labour time. On the plus side, single-storey rear roofs rarely need full scaffolding, which keeps costs down. A dormer up at second-floor height is the opposite case, and the access bill goes up with it.
Flat Roofs in Crewe: Your Questions
Will Cheshire East Council need to approve my new flat roof?
Re-covering an existing flat roof, even in a different membrane, doesn't normally need planning permission. If you're replacing more than a quarter of the roof, Building Regulations apply and it will usually need insulating to current standards, which we build into the quote. A brand new flat-roofed extension is a different matter: check the permitted development rules, or ask Cheshire East Council, before you build.
Why does water sit on my extension roof after rain?
Usually the fall has gone. Over the years the timber deck sags between the joists, or the roof was laid nearly level in the first place. A puddle that dries within a day isn't an emergency, but one that lingers for days will shorten the life of the covering. We fix it with firrings or tapered insulation when we re-roof.
Which flat roof system would you recommend for a Crewe extension?
For a typical domestic extension, EPDM more often than not, because it's good value over its lifespan and suits roofs that aren't walked on. GRP comes next where there's foot traffic. Felt still makes sense on garages and outbuildings when the budget is tight. You'll get our honest pick for your roof at the survey.
Can solar panels go on a flat roof?
Yes, and a flat roof lets the panels be angled towards the south. The roof needs to be in good shape first, because lifting panels later to fix a leak is expensive. GRP and good-quality EPDM both work well under panels. If solar is on your list, tell us at the survey so we can allow for the fixings.
Is it worth repairing my flat roof instead of replacing it?
If the problem is one split or a lifted edge on an otherwise sound roof, a repair is fine and much cheaper. If the felt is crazed all over, the deck is soft or it has been patched several times already, you're paying for repairs that won't last. We'll tell you which camp yours falls into, with photos to back it up.
What To Do In Crewe

Lyceum Theatre
Learn More about Lyceum Theatre
Queens Park
Learn More about Queens Park
