EPDM Roofs in Deeside

Want a flat roof that won't need patching every autumn?

EPDM membranes installed, replaced and repaired on Deeside flat roofs of every size.

CALL US HERE - 01244 740253

GET A FREE ASSESSMENT

An aerial view shows a partially reroofed brick house with new dark gray tiles on one side and old, weathered tiles on left.View from above of a flat, dark gray roof, looking down toward a suburban street with parked cars and apartment buildings.

On an EPDM roof, the membrane is rarely the part that fails. It's what surrounds it: the edge trim, the outlet, the upstand where the roof meets a wall. Keep that in mind when you're comparing quotes for an EPDM roof in Deeside, because the weather here finds those weak details fast.

EPDM is a synthetic rubber sheet supplied in big pieces. On most house roofs one sheet covers the lot. It's bonded to the deck, turned up the walls and finished with trims, and fitted properly it can last up to 40 years.

We install, replace and repair EPDM on extensions, garages and dormers. Compare it with GRP and felt on our Deeside flat roofs page, or browse our other local services on the Deeside area page.

EPDM Work We Carry Out In Deeside

New EPDM roofs

For a new extension, or a roof coming off felt, we lay a fresh deck, add insulation if you want it, and bond the membrane down in one piece. Outlets, upstands and trims are part of the same job. You end up with a quiet, dark grey roof with no exposed laps for rain to get into.

Felt to EPDM

A lot of older garages and extensions around Deeside are still under felt. Once that felt starts blistering and leaking, swapping to EPDM is a popular upgrade. The felt is stripped off, the deck checked and renewed where needed, and the falls corrected so the new membrane drains the way it should.

EPDM repairs

EPDM is easy to repair if you catch problems early. Punctures, lifted corners and failed joints at outlets or roof lights can be cleaned, primed and patched with matching membrane. Trims that pulled loose in a storm can be refixed. We'll tell you plainly if a repair will do or the roof is past it.

1,000+ Roofing Projects

Friendly & Reliable Team

Getting EPDM Details Right For Deeside's Exposure

Deeside lies flat and open along the Dee estuary, so wind has a long run-up before it reaches your roof. Across a flat roof, gusts create suction that tries to peel the membrane up from its edges. Full adhesion across the deck and perimeter trims fixed at close centres resist that. A loose-laid sheet, or a trim held on with a few nails, is exactly where the wind gets its grip.

Rain is the other half of it. Outlets need sizing for heavy bursts, not average drizzle, and they need a proper preformed EPDM outlet, not membrane cut and glued round a pipe. Where the roof meets a wall, the membrane should rise at least 150mm and be capped with a flashing or trim. Those few details decide how long the roof lasts.

How We Install An EPDM Roof

Measure and quote

We survey the roof, check the falls and outlets, and look at the deck from inside if possible. A written and verbal estimate follows, often with more than one membrane grade so you can compare.

Strip and prepare

The old covering is removed and soft decking replaced. If water has been sitting, the falls are corrected with firrings or tapered boards. The deck is swept, dried and primed where the system needs it.

Bond and detail

The sheet is laid out to relax, then adhered to the deck. Upstands, corners and outlets are formed with the correct accessories, so every junction is sealed by design and not by a tube of mastic.

Trim and hand over

Edge trims and drip details go on and the gutter gets checked to make sure it takes the flow. Photos and videos of each stage come through during the job, and both materials and workmanship are guaranteed.

Why EPDM Makes Sense For Many Deeside Homes

  • One sheet across most domestic roofs, so there are no laps in the middle for rain to creep into.
  • Can last up to 40 years, a good return on a fairly modest upfront cost.
  • Light enough for dormers and older garages where a heavier system might need extra support.
  • Handles frost, summer heat and UV without cracking, which suits exposed roofs near the estuary.
  • Quick to fit with little disruption, and fully recyclable when it eventually comes off.
An aerial view of a building with a partially tiled roof, neighboring houses, and a green field under a cloudy sky.A house roof under construction, featuring new dark tiles, partially installed solar panels, and surrounding scaffolding.

EPDM Roof Costs In Deeside

Prices for EPDM begin around £1,500 and rarely climb over £4,000. Where yours sits depends on size, membrane grade, whether insulation goes in and how much decking needs replacing. A simple garage is towards the bottom. A big extension with roof lights and several upstands is towards the top.

The local factor we tend to see most is fall. Many older Deeside flat roofs were built close to dead level, and in a wet climate that means puddles. Firring the roof to restore a proper fall adds a little to the price and saves a lot of bother. Where the main roof's downpipe dumps straight onto the extension, we may suggest re-routing it too.

EPDM Roofs in Deeside: Your Questions

Does an EPDM re-roof need approval in Flintshire?

Planning permission isn't normally needed to re-cover an existing flat roof. Building Regulations are the thing to watch. In Wales, re-covering a large part of a roof can count as renovating a thermal element, which usually means upgrading the insulation and involving building control. Flintshire County Council's building control team can confirm for your roof, and we'll raise it at the survey.

How do you stop the wind lifting an EPDM roof?

By bonding it fully to the deck rather than laying it loose, and fixing the perimeter trims mechanically at close centres. On open ground near the estuary the edges are where wind attacks, so that's where the care goes. A well-adhered membrane with sound trims stays down through a proper winter gale.

Is EPDM a good choice for a dormer in Deeside?

Usually, yes. Dormers are exposed, awkward to reach and don't want heavy materials on them. EPDM is light, can be laid in one piece on most dormer roofs and needs little maintenance afterwards, which matters when getting up there means ladders or scaffold. We'll check the dormer cheeks and flashings while we're up there.

Can you lay EPDM on top of the felt that's already there?

We don't recommend it. Old felt hides soft decking and holds moisture, and adhesive won't bond reliably to a weathered, gritty surface. Stripping back lets us check the deck and fix the falls, giving the new membrane a proper start. Overlaying looks cheaper but often costs the roof years.

Do I need to clear leaves off an EPDM roof?

Yes, once or twice a year, especially in late autumn. Leaves and moss gather around outlets and trims, and a blocked outlet turns a flat roof into a paddling pool in Deeside rain. A soft brush and a quick look at the outlet is usually enough. Skip the pressure washer and anything sharp.

What To Do In Deeside

EPDM Roofs Elsewhere In Cheshire And North Wales