EPDM Roofs in Whitchurch

Thinking about EPDM for that kitchen extension or dormer?

EPDM membrane fitted, replaced and repaired on Whitchurch extensions, dormers and garages

CALL US HERE - 01244 740253

GET A FREE ASSESSMENT

An aerial view shows a partially reroofed brick house with new dark gray tiles on one side and old, weathered tiles on left.View from above of a flat, dark gray roof, looking down toward a suburban street with parked cars and apartment buildings.

EPDM is the black rubber membrane you've probably seen on flat roofs everywhere, usually laid in one big sheet. We fit EPDM roofs in Whitchurch on the jobs it does best: single-storey extensions, dormer tops, garages and the odd outbuilding that needs something lighter than felt.

Most of what makes a good EPDM roof isn't the rubber itself. It's a dry, flat deck, a sensible fall, and careful work at the edges, upstands and outlets. Get those right and the membrane has an easy life.

If you're weighing it up against GRP or felt, our flat roofs page for Whitchurch compares all three.

EPDM jobs we take on in Whitchurch

New EPDM roofs

For a new extension or garage, EPDM goes onto a fresh deck with insulation where it's needed. It's quick to lay, so the building is open to the weather for less time, which matters when the forecast can't make its mind up. Trims and outlets are fitted as part of the same job.

Swapping old felt for EPDM

A very common change. We strip the old felt, check and replace any boards that have gone soft, then lay EPDM in its place. It suits back extensions where the felt has failed more than once already, because the joins that kept leaking simply aren't there any more. The new roof is usually lighter, too.

Dormers and small roofs

Dormer tops are small, awkward and high up, and they tend to leak at the edges. A single EPDM sheet with proper trims and a sealed upstand against the main roof cures most of that. These can be done alongside slate or tile repairs to the roof around them, all from the same scaffold.

1,000+ Roofing Projects

Friendly & Reliable Team

EPDM on Whitchurch homes, old and new

Whitchurch has grown well beyond the old streets at its centre, and a lot of houses round the edge of town have had a back extension or a garage added with a flat roof. That's exactly where EPDM earns its keep. It's light, it shrugs off the frosty nights you get on low-lying north Shropshire farmland, and it stays flexible as a building shifts slightly with the seasons. It's also quick to put on, which helps when an extension is half built and waiting for a roof.

Behind the older frontages on the High Street and Watergate, back wings and later additions often carry small flat roofs you can't see from the street. EPDM is a tidy, quiet way to re-cover those, though anything on a listed building still needs care. Nobody wants a chunky plastic trim showing on a period house, either. More about the town and the area we cover is on our Whitchurch roofing page.

Our EPDM installation process

Free survey

We measure up, check the deck and look at how water leaves the roof. You get a written and verbal estimate, often with a choice of membrane grade. We also ask how you use the space below, since that decides whether insulation is needed.

Deck and falls

The old covering comes off, any soft board is swapped out, and the deck is set to fall so rain runs to the gutter or outlet instead of pooling. New edge timbers go in so the trims have something firm to fix to.

Bond and detail

The EPDM sheet is bonded to the deck, then the edges, wall upstands and outlets are finished with trims and flashings. This detail work is where most of the time goes, and it's what keeps the roof dry.

Check and hand over

We go round every edge and outlet, clear the site and send you the photos and video. The roof comes with guarantees covering the membrane and our work. We'll also tell you what to keep an eye on, which is mostly the outlet.

Reasons to choose EPDM from us in Whitchurch

  • One-piece EPDM on most domestic roofs, so there are very few joins for water to work at.
  • Careful edge, upstand and outlet detailing, which is where flat roofs usually let go.
  • Light enough for garages and older outbuildings without strengthening the joists.
  • Fair pricing, with most installations coming in between £1,500 and £4,000.
  • Photo and video updates, and guarantees on both materials and workmanship.
An aerial view of a building with a partially tiled roof, neighboring houses, and a green field under a cloudy sky.A house roof under construction, featuring new dark tiles, partially installed solar panels, and surrounding scaffolding.

How much is an EPDM roof in Whitchurch?

For most EPDM roofs the bill starts near £1,500 and stays short of £4,000. The grade of membrane makes a difference, as do the size of the roof and whether insulation goes in at the same time.

On older Whitchurch properties the deck is the wildcard. A garage with original boards that have been damp for years will need new decking, and that adds labour and materials. Small, high roofs like dormers cost more for their size than a big flat garage, because of the access and the fiddly detail work.

EPDM Roofs in Whitchurch: Your Questions

Is EPDM allowed on a listed building or in Whitchurch's conservation area?

On an unlisted house, re-covering a flat roof in EPDM is normally just maintenance, and in the conservation area that's usually still true where the roof can't be seen. On a listed building, changing the roof covering can need listed building consent from Shropshire Council, so check first, especially if the roof is visible.

My extension faces open fields and takes the wind. Will EPDM stay put?

Yes, if it's fitted properly. The membrane is bonded across the whole deck and held at the edges with trims, which is what stops wind getting under it. On a very exposed roof we pay extra attention to the edge on the windward side.

How soon could you fit an EPDM roof in Whitchurch?

Once you've accepted the quote from your free survey, we'll give you a start date. Laying is quick on most domestic roofs, but bonding needs a dry spell, so we'll keep you posted if the weather pushes things back a day or so.

What's the difference between EPDM and a rubber roof?

EPDM is a type of rubber roofing, and the most common one, so when people say rubber roof they usually mean EPDM. There are other rubber and single-ply membranes, and our rubber roofs page covers the wider range. If you're unsure which to pick, we'll talk it through at the survey.

Can EPDM go over my existing felt?

It's sometimes possible, but we rarely recommend it. Old felt can hide wet boards, and covering them traps the problem underneath. Stripping back lets us check the deck and gives the new membrane a clean, dry surface to bond to.

What To Do In Whitchurch

EPDM Roofs Elsewhere In Cheshire And North Wales