Chimney Repairs in Wrexham
Spotted damp on the chimney breast after heavy rain?
Repointing, flashing, rebuilds and removals on Wrexham's brick chimney stacks.
CALL US HERE - 01244 740253GET A FREE ASSESSMENT


Chimney repairs in Wrexham mostly mean brick. The stack sits higher than anything else on the house, takes weather from every side and is often the least looked-at part of the roof. When it fails, it shows up as damp on a chimney breast, a stain on a bedroom ceiling or bits of mortar in the gutter.
We repoint stacks, replace lead flashing, rebuild damaged chimneys and take down ones you no longer need. Every job starts with a free inspection and quote. In an emergency, such as a stack damaged in a storm, we can attend within 24 hours.
A damp patch near the stack could be the chimney or the roof next to it, and plenty of people guess wrong. If the trouble turns out to be the slates around it, see roof repairs in Wrexham. Our Wrexham page covers the rest of our local work.
Chimney work we carry out in Wrexham
Repointing and brickwork
Mortar is meant to be the weak point, so it wears before the bricks do. Once the joints open up, water gets in. We rake out the old mortar and repoint, and replace any flaking or cracked bricks with a good match. On older stacks we use lime mortar where the original was lime, because hard cement can damage soft old bricks.
Lead flashing and pots
The joint between stack and roof is sealed with lead. When it splits, lifts or was badly fitted, water runs straight down the chimney breast. We replace flashings and soakers, and rebed or replace loose chimney pots along with the flaunching, which is the sloped mortar cap the pots sit in.
Rebuilds and removals
Some stacks are past repointing. They lean, the bricks are failing, or the top has been knocked about by wind. We take them down to sound brickwork and rebuild. If you no longer use the fireplace, taking the stack down below the roofline and slating over can be the cheaper long-term answer.

1,000+ Roofing Projects
Friendly & Reliable Team
Wrexham's chimneys and the weather they face
Wrexham grew on coal. Mining villages such as Rhos and Brymbo, and the older streets of the city itself, were built when every room with a fire had its own flue. That has left a lot of stacks, many of them shared between terraced houses and plenty no longer serving a working fireplace. A stack nobody uses still catches all the weather, and it gets far less attention than one with a fire burning under it.
Up on the hills to the west, exposure is the issue. A stack on a house on the side of Brymbo Hill takes driving rain and frost as a matter of routine. Water gets into the mortar joints, freezes and pushes the brick faces off over a few winters. The brick itself is often good local red brick. It's the mortar and the flashing that give way first.
What happens on a chimney repair
Inspection
We get up to the stack, usually from roof ladders or a small scaffold, and look at the pointing, bricks, pots, flaunching and lead. You get photos of what we found and a free quote that explains the options.
Access
Chimneys need safe access all the way round. On most jobs that means a chimney scaffold built around the stack. It's often the biggest single cost of a chimney repair, so we'll tell you if a small job can be done more simply.
Repair
Depending on what the stack needs, old mortar is raked out and repointed, bricks replaced, flaunching rebuilt and lead renewed. For a rebuild, we take the stack down course by course and build it back up with matching brick.
Check and hand over
We check the flashing is watertight, clear debris from the roof and gutters, and you get photos and video of the stack once it's done. The guarantee covers materials and workmanship. Then the scaffold comes down and we're out of your way.
Why use our roofers for chimney work in Wrexham
- Roofing and chimney work in one team, so the lead, slate and brickwork round the stack are done together.
- Lime mortar used on older stacks where it's needed, so the brickwork can breathe.
- Storm-damaged stack? We aim to be there inside 24 hours.
- Photos of every stage, because nobody can see the top of their own chimney.
- Straight advice on whether to repair, rebuild or remove a stack you no longer use.


How much do chimney repairs cost in Wrexham?
Chimney repairs usually start at around £250 for smaller jobs like rebedding a pot or patching flashing. A full rebuild can reach £1,200 or more. Height, access, the condition of the stack, the materials and the number of stacks needing work all move the price.
The local factor is the stacks themselves. Plenty of older terraces have shared stacks sitting across the party wall, so the job may involve your neighbour's side and a conversation about splitting the cost. Tall stacks on three-storey houses, and exposed stacks on hillside homes, may need more scaffold, and that adds to the bill.
Chimney Repairs in Wrexham: Your Questions
Do I need permission to take down or rebuild a chimney in Wrexham?
Repointing, or rebuilding to match, doesn't normally need planning permission. Taking a stack down is different. On a listed building, Wrexham County Borough Council will need to grant consent before a stack comes down, and in a conservation area a visible chimney can be part of the street's character, so check with the council first. Building Regulations matter if a chimney breast comes out, because whatever is left above must be properly supported.
Why is the mortar falling out of my chimney but not my walls?
Because the stack gets weather from every side, all year round. Rain soaks it from the west, frost works on the wet joints, and there are no eaves or neighbouring walls to shelter it. Walls lower down get some protection. On older Wrexham houses the original mortar may also be lime, and patching it with hard cement can make things worse.
Can you repair a shared chimney on a Wrexham terrace?
Yes. Shared stacks are common on terraced streets, and the work often has to cover both sides to be worth doing. We can quote for the whole stack so you can share the figure with your neighbour. If only your side is done, we make sure the repair ties in properly with the brickwork next door.
Is my damp chimney breast caused by the chimney or the roof?
It could be either. Common causes are failed flashing, porous brickwork, an uncapped disused flue, or condensation inside a chimney that's been sealed up without ventilation. Each has a different fix. We inspect from the roof and the loft, and show you photos of what we find before recommending anything.
Should I cap my chimney if I don't use the fireplace?
Yes, but keep some ventilation. A cap stops rain going down the flue. Air still needs to move, otherwise moisture builds up inside the chimney and shows as damp on the breast. A vented cap at the top and an air vent in the room below usually does the job.
What To Do In Wrexham

National Trust - Erddig
Learn More about National Trust - Erddig
Xplore! Science Discovery Centre
Learn More about Xplore! Science Discovery Centre
